Product categories

Victron Cyrix-ct 12-24V 120A

1 133 CZK 936 CZK without VAT
Common price: 1 364 CZK

To send: 4 pcs

Code: SOPGWL0041 PN: CYR010120011 Warranty: 26 months
Victron Cyrix-ct 12/24V-120A The Cyrix Battery Combiner is a microprocessor controlled heavy duty relay that automatically connects batteries in parallel when one of them has reached a pre-set voltage (indicating that the... more

Victron Cyrix-ct 12/24V-120A

The Cyrix Battery Combiner is a microprocessor controlled heavy duty relay that automatically connects batteries in parallel when one of them has reached a pre-set voltage (indicating that the battery is being charged), and disconnects when the voltage decreases below float level (indicating that one or more batteries are being discharged). Cyrix Battery Combiners are an excellent replacement for diode isolators. The main feature is that there is virtually no voltage loss so that the output voltage of alternators or battery chargers does not need to be increased.

Intelligent battery monitoring to prevent unwanted switching
Some battery combiners (also called voltage controlled relay, or split charge relay) will disconnect a battery in case of a short but high amperage load. A battery combiner also may fail to connect a large but discharged battery bank because the DC voltage immediately drops below the disengage value once the batteries are connected.
The software of the Cyrix-ct 12/24 does more than simply connect and disconnect based on battery voltage and with a fixed time delay. The Cyrix-ct 12/24 looks at the general trend (voltage increasing or decreasing) and reverses a previous action only if the trend has reversed during a certain period of time. The time delay depends on the voltage deviation from the trend.

Long bolts to allow connection of more than one power cable
Cyrix 12/24-120: 13 mm (M6)
Cyrix 12/24-230: 16 mm (M8)

Protection against overheating (due to a long duration overload e.g.)
The Cyrix will disengage in case of excessive contact temperature, and reengage again after it has cooled down.

LED status indication (Cyrix 12/24 230 only)

12/24 V auto ranging
The Cyrix-ct 12/24 automatically detects system voltage.

No voltage loss
Cyrix battery combiners are an excellent replacement for diode isolators. The main feature is that there is virtually no voltage loss so that the output voltage of alternators or battery chargers does not need to be increased.

Prioritising the starter battery
In a typical setup the alternator is directly connected to the starter battery. The accessory battery, and possibly also a bow thruster and other batteries are each connected to the starter battery with Cyrix battery combiners. When a Cyrix senses that the starter battery has reached the connect voltage it will engage, to allow for parallel charging of the other batteries.

Bidirectional voltage sensing and power supply from both batteries
The Cyrix senses the voltage of both connected batteries. It will therefore also engage if for example the accessory battery is being charged by a battery charger.
The Cyrix-ct 12/24 has a dual power supply. It will therefore also close if the voltage on one battery is too low to operate the Cyrix.
In order to prevent unexpected operation during installation or when one battery has been disconnected, the Cyrix-ct 12/24 will not close if the voltage on one of the two battery connections is lower than 2 V (12 V battery) or 4 V (24 V battery).

Parallel connection in case of emergency (Start Assist)
The Cyrix can also be engaged with a push button (Cyrix remains engaged during 30 seconds) or a switch to connect batteries in parallel manually.
This is especially useful in case of emergency when the starter battery is discharged or damaged.

SPECIFICATIONS

System voltage: 12/24 V (auto-detection)
Continuous current: 120 A
Cranking rating (5 seconds): 180 A
Connect voltage: from 13 V to 13,8 V & from 26 to 27,6 V with intelligent trend detection
Disconnect voltage: from 11 V to 12,8 V & from 22 to 25,7 V with intelligent trend detection
Connection: 13 mm bolt (M6)
Protection category: IP54
Weight: 0,11 kg
Dimensions: 80 x 46 x 46 mm



Brand
Manufacturer :  VICTRON
Type specification :  Other
Technical specification
Ingress protection :  IP54
Inputs and outputs
Connector :  M6
Power supply
Max. Input Current (A) :  120
Input Voltage (V) :  12/24
Warranty
Warranty period CRN (months) :  26
Warranty period EU (months) :  26
Physical properties
Weight (kg) :  0.11
Dimensions :  80 × 46 × 46 mm
Hodnocení můžou přidávat pouze přihlášení uživatelé a ti kteří produkt zakoupili

Similar products

Scroll